Chisel tines

High elasticity and recovery of the initial geometry

Characteristics:

Special, high elasticity steel with high capacity to recover initial geometry.

Specific integral heat treatment that provides each material with optimum characteristics.

Use:

Working in dry soil is recommended.

A working depth of from 18-22 cm is recommended.

The recommended power is between 25 and 40 hp per metre of working width.

Working speed should be high (7 to 9 km/h) to improve efficiency.

Chisel tines should be used for cultivators that are going to work on dry soil. Chisel tines are suitable for aggressive tillage work at a depth of about 25 cm. The chisel tines must be assembled with a spring so that any obstacles in the soil that is being tilled can be avoided and so that the initial geometry can be recovered and not warp.

2461 - 2467

Download catalogue

2461-2467

Ref.	G	A	B	C	D	E	F	Grs.	B	₴
2466	25x25	393	370	17,5	45	M12	217	3500	200
2467	30x30	470	397	17	45	M12	275	5500	125
2467-35	35x35	470	402	17	45	M12	275	7500	125
2461-C	40x30	495	368	18,5	40-50	M12	296	6900	90
2461-CL	40x30	470	492	26	45	M12	215	9620	70
2464-A	40x40	470	500	26	45	M12	245	11000	50
2464-AL	40x40	525	575	26	45	M12	230	12700	30
2464-AL CA1	40x40	525	575	26	57-57	M12	230	12700	30
2461-B	45x20	500	355	17	40-50	M12	296	5200	100
2461-D	45x20	415	450	17	40-50	M12	280	6200	100
2462-A	50x25	450	582	21,5	40-50	M12	280	10300	45
2462-B	50x30	455	587	21,5	40-50	M12	280	12500	40
2462-B-A16	50x30	545	660	17	56	M12	330	14150	35
2462-B A24 CA2	50x30	455	587	26	45-57	M12	280	12500	40
2462-C	50x30	560	480	20	57	M14	330	11700	80